The plastic blanks which generally come standard in the front spoiler kits are generally held in by small plastic grommets.


These are very simple to remove. Simply apply pressure to the back of the grommet and unscrew the screw piece. With the plastic screw out the grommet easily slides out.

Once the grommets are out, the plastic blank can be easily removed from the spoiler.

To make up the mesh you need to basically form the same shape as the plastic blank. Just trace around the blank allowing enough mesh to form the sides.

Shape the mesh around the blank, you will need to strategically cut the mesh in order to successfully shape it to suit.

With the mesh now shaped around the outside, trace and cut out spotlight holes if required.

Sit the mesh in place of the blanks, & form the mesh in the center cavaties if required. Aluminium mesh is very easy to work with and it is'nt hard to get a good looking result.

Fix the mesh by either riveting, or bolting into the spoiler. Be sure to take care when fitting this because it is generally permanent. A softer option is to simply replace the grommets as they are design to hold this type of weight.

Whilst the spoiler is off make any final adjustments required and ensure the mesh is fully secure. Now is a good time to clean under the spoiler and check everything else out.

Refit the spoiler carefully.

Before!

After!!!